reorder signal

См. также в других словарях:

• reorder signal —    Audible tone, faster than a busy signal, that indicates all switching paths needed to connect a call are in use …   IT glossary of terms, acronyms and abbreviations

• Reorder tone — The reorder tone, also known as the fast busy tone, is the congestion tone or all trunks busy (ATB) tone of a public switched telephone network. It varies from country to country; in the USA it is a dual frequency tone of 480 Hz and 620 Hz at a… …   Wikipedia

• Busy signal — For other uses, see Busy signal (disambiguation). A busy signal (or busy tone or engaged tone) in telephony is an audible or visual signal to the calling party that indicates failure to complete the requested connection of that particular… …   Wikipedia

• Permanent signal — (PS) in US telephony jargon, or Permanent Loop in British usage, is a condition in which a POTS line is off hook without connection for an extended period of time. This is indicated in modern switches by the silent termination after the off hook… …   Wikipedia

• Autovon — AUTOVON, short for Automatic Voice Network , was an American military phone system built in 1963 to survive nuclear attacks. AUTOVON was first established in the United States, using the Army s SCAN (Switch Communications Automated Network)… …   Wikipedia

• сигнал освобождения цепи — — [Л.Г.Суменко. Англо русский словарь по информационным технологиям. М.: ГП ЦНИИС, 2003.] Тематики информационные технологии в целом EN circuit available signalreorder signal …   Справочник технического переводчика

• vacant code intercept —    Routes all calls erroneously dialed using an unassigned first digit to the attendant, a busy signal, a reorder signal, or to a recording …   IT glossary of terms, acronyms and abbreviations

• сигнал перегрузки — — [Л.Г.Суменко. Англо русский словарь по информационным технологиям. М.: ГП ЦНИИС, 2003.] Тематики информационные технологии в целом EN reorder signal …   Справочник технического переводчика

• Special information tones — In telephony, a special information tone (SIT) is an international standard three beep signal indicating a call did not go through and usually precedes a recorded announcement explaining the problem.[1] As the SIT is well known in many countries …   Wikipedia

• Disconnect tone — A disconnect tone in telephony is a tone provided to the remaining party to a call after the remote party hangs up. Typically, the disconnect tone is a few cycles of the reorder or busy tone (e.g. in US), or between five and fifteen seconds of… …   Wikipedia

• PA-8000 — HP PA 8000. The PA 8000 (PCX U), code named Onyx, is a microprocessor developed and fabricated by Hewlett Packard (HP) that implemented the PA RISC 2.0 instruction set architecture (ISA).[1] It was a completely new design with no circuitr …   Wikipedia